[LT Armor Loadouts] Expensive Greaves

CarrionPeacock · 12-11-2019, 07:58 AM

If the hoplites were cutting corners to save money, why didn't they replace the greaves with linen as well, or keep the better bronze corselet while replacing graves with linen shinguards (or trousers)?

I can accept working with bronze is as hard as iron, but I'm not convinced why it's not using segmented plate instead of plate. As I understand, Plate cost is due to the difficulty to make large plates like that of a breastplate with iron, while segmented plate is a "compromise" design by using multiple smaller plates, that's however with torso in mind. Shins are much smaller than torso and each segment of a lorica segmentata seems large enough to cover it. That would reduce the cost to $1,320.

Also, if greaves were such a close fit as to be unable to be passed from a father to a son, shouldn't it be equivalent to a Expert/Masterful Tailoring? That would further increase the cost...

12-11-2019, 07:58 AM	#9
CarrionPeacock Join Date: May 2018	Re: [LT Armor Loadouts] Expensive Greaves If the hoplites were cutting corners to save money, why didn't they replace the greaves with linen as well, or keep the better bronze corselet while replacing graves with linen shinguards (or trousers)? I can accept working with bronze is as hard as iron, but I'm not convinced why it's not using segmented plate instead of plate. As I understand, Plate cost is due to the difficulty to make large plates like that of a breastplate with iron, while segmented plate is a "compromise" design by using multiple smaller plates, that's however with torso in mind. Shins are much smaller than torso and each segment of a lorica segmentata seems large enough to cover it. That would reduce the cost to $1,320. Also, if greaves were such a close fit as to be unable to be passed from a father to a son, shouldn't it be equivalent to a Expert/Masterful Tailoring? That would further increase the cost...