Buriable Spaceship

[ShadowCharlatan]

Hey, looking for input
In short I want to build a spaceship that is made so that it can go to a location, excavate a hole just deep enough for it to be flat on the surface and conceal itself.


Using the building design suggestion from Pyramid 34

SM+8
Upper Floors
[1, 2, 3]Armor, Exotic Laminate (dDR 50)
[4]Tertiary Battery (30 Fixed mounts with 20cm missile launchers)
[5, 6, Core]Hangar Bay (30 tons each)

Middle
[1]Armor, Exotic Laminate (dDR 50)
[2]Habitat
[3]Habitat
[4]Habitat
[5]Habitat
[6]Open Space

Lower
[1]Armor, Exotic Laminate (dDR 50)
[2]Cargo Hold (50 tons)
[3]Nanofactory
[4]Cloaking Device
[5]Super Reactionless Engine
[6]Control Room
[Core]Power Plant, Vacuum Energy (3 power points)

So what I was thinking was either another ship scouts and pre-excavates a site with (TL12 multifunction Construction/Disassembler Nanoswarms) or the buriable spaceship would carry them (most likely in the cargo bay)

For concealment on the surface I was thinking the Biomorphic design feature that could change according to what the surface is like, so if it's a grassy area then it will replicate a grassy area (Utility Fog)

A concealed driveway to the Hangar Bay doors will be built using Utility Fog (the 3 hangar bays are so the doors will accommodate a Wheeled ATV (UT pg.225 SM+5)

The heavy armor for the topmost level is in place under the assumption that it will be found and assaulted.

With the submerged Cargo Bay additional tunnels could be creates at a later time.

Any habitats will have Total Life Support