Thread: Curing times?
View Single Post
Old 12-22-2021, 08:10 PM   #3
afschell
 
Join Date: Mar 2006
Location: Southeastern PA
Default Re: Curing times?

I'm using a jeweler/computer sized wire cutter. Not super fine but i can get to the detail.

What I did find was that I could cut the middle of a support and the whole support could be snapped off without further snipping.

How flexible should the prints be? Should I be expecting the flexibility of the injection mold figures that are purchased or something a lot more brittle?

Last edited by afschell; 12-22-2021 at 08:48 PM.
afschell is offline   Reply With Quote