1.5" Hex Base Adapters for pre-painted minis or pawns

malchidael · 08-04-2018, 07:46 PM

I have put together a set of 3D printed bases to use my large collection of pre-painted plastic minis with 1.5" hex-based TFT.

The 3-hex and 4-hex adapters have a little wiggle room, so some putty or 2-sided tape will hold the 2" based minis in place. The 1-hex adapter seems to fit 1" based minis pretty tightly.

The standard 7-hex base is just flat - I'll have to glue dragon minis on the base, or use the alternate 7-hex base with "Huge" sized minis.

They can also be used with cardboard "pawn" bases (although I have another set with integral pawn bases that I'll probably upload).

I know I could have done the same with plasticard, but I think this looks better (well, better than what I can do with plasticard).

The bases are on Thingiverse You may need an account to download.

08-04-2018, 07:46 PM	#1
malchidael Join Date: Jul 2018 Location: Near Milwaukee, WI	1.5" Hex Base Adapters for pre-painted minis or pawns I have put together a set of 3D printed bases to use my large collection of pre-painted plastic minis with 1.5" hex-based TFT. The 3-hex and 4-hex adapters have a little wiggle room, so some putty or 2-sided tape will hold the 2" based minis in place. The 1-hex adapter seems to fit 1" based minis pretty tightly. The standard 7-hex base is just flat - I'll have to glue dragon minis on the base, or use the alternate 7-hex base with "Huge" sized minis. They can also be used with cardboard "pawn" bases (although I have another set with integral pawn bases that I'll probably upload). I know I could have done the same with plasticard, but I think this looks better (well, better than what I can do with plasticard). The bases are on Thingiverse You may need an account to download.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode