Steve Jackson Games Forums - View Single Post - Interest in 3d printable track pieces for 'classic'?

ammulder · 02-11-2018, 05:16 PM

I looked in GitHub. I didn't realize how many pieces you have. Can you suggest a small subset that I can start with just to make sure this it going to work reasonably? Maybe a couple straights and 90 degree turns and a non-track fuller tiles, all at "level 1"?

The fantasy tiles seem to use a predominantly 2" grid (the stupidly large variety of OpenLOCK base shapes notwithstanding), so I'll probably need to make some adjustments to work better if this will rely more on 3" tiles. That's fine, there are already reasons that a 1" grid might work better, I just haven't gone there yet. :)

02-11-2018, 05:16 PM	#22
ammulder Join Date: Sep 2010 Location: Philadelphia Area	Re: Interest in 3d printable track pieces for 'classic'? I looked in GitHub. I didn't realize how many pieces you have. Can you suggest a small subset that I can start with just to make sure this it going to work reasonably? Maybe a couple straights and 90 degree turns and a non-track fuller tiles, all at "level 1"? The fantasy tiles seem to use a predominantly 2" grid (the stupidly large variety of OpenLOCK base shapes notwithstanding), so I'll probably need to make some adjustments to work better if this will rely more on 3" tiles. That's fine, there are already reasons that a 1" grid might work better, I just haven't gone there yet. :)