Re: 3d Printing
I have a DaVinci Jr 1.0 and a DaVinci 1.0. Both work very well, and are fairly simple machines to operate.
Now, don't, even for a second, think you're going to print quality miniatures off of these machines. You can get some effectively shaped pieces of plastic, and even some that look really good, but, you're not getting the quality of a purchased miniature.
I recommend looking at both Thingiverse and TinkerCAD. TinkerCAD is really easy to use and you can make some fairly effective tokens and figures on it. Dutchmogul, a maker you'll see a lot of on Thinigverse if you're looking for figures, uses TinkerCAD for his designs.
|