Quote:
Originally Posted by Steve Jackson
I'm collecting 54mm fighters and wizards. Which is a bit on the large side if you think of 28mm as normal. But not that large in an absolute sense.
|
That's
weird. A 54mm figure isn't
that large. It's not going to be a
fast print, but just about any DLP printer should be able to handle it.
I loaded the demo paladin from Hero Forge into the slicer and doubled its size. It became ~80.5mm tall. That does count its base and the wings on its helmet (I can slice the base off). The estimated print time is five hours, thirteen minutes. A long print, for sure, but
nothing outside the normal times. (I've had 24-hour print times on my FDMs for some larger pieces of terrain.)
(
Image from Slicer; the yellow bits are supports to assist in printing.)
Once I get the hang of the printer, I'll be happy to try to print one (or more) for you.