Quote:
Originally Posted by Worldwalker
Acetone.
|
But I don't want to put acetone in . . . sensitive places.
Seriously, that was just me being silly.
Here is a
Black Knight and a "Starhost Veteran on Raptor" from One-Page Rules (citing the source as it's a premium model).
Got to say I'm
not impressed with "pre-engineered supports." I've printed two models with them and both have failed because there weren't enough supports.
I used the pre-engineered support model for the 2nd printing of the Starhost (seen above) but added several supports to his gun (it didn't print properly the first time) and it worked after I fixed it.
Printing my Ork's new Bloodbowl Manager again, after adding supports to his right leg. (And that's I'm printing a figure for my Ork. Not my Ork Team--I have an Ork. Everyone should have an Ork. My Ork bought me the wash/cure station I'm using.)