View Single Post
Old 03-19-2018, 01:00 AM   #13
Mark Skarr
Forum Pervert
(If you have to ask . . .)
 
Mark Skarr's Avatar
 
Join Date: Feb 2005
Location: Somewhere high up.
Default Re: Cleaning DLP Mini prints

Bobb has been unable to get any good photos of the figures as the included resin (green) is translucent, and it does a great job of not showing up details on pictures. Due to an unexpected blizzard here in Denver, we also could not prime any of the figures.

After several prints (most good, a few failures, but more good than bad--including a bunch of test Lego guns Bobb wanted to try out), I did purchase a pair of figures (STLs) from Hero Forge. Todd Diallo, from my Infinite Weirdo's game, and my sister's Tiefling, Ink, from our D&D game. Todd came out great, Ink . . . the slicer decided to not support her tail or her crossbow so . . . they didn't work. I've got her ready for another test when my next print is done.

I've put the 2x scale Hero Forge Paladin (sans base) in to run overnight. It looks to be a huge ordeal to clean the supports (it needs a lot), but I'll see tomorrow.
Mark Skarr is offline   Reply With Quote